Three Phase Thyristor Trigger Module
Product Overview
The Three Phase Thyristor Trigger Module coordinates firing signals for a compatible three-phase thyristor circuit. The HXCF-3 reference identifies the corresponding product. It controls when the power devices begin conducting; it does not carry the load current itself. Its outputs connect the control system to the gates of the thyristors in the main circuit.
Timing and channel assignment are central to this job. Each firing output must correspond to the correct branch and the circuit's phase relationships. Simply producing pulses is not the whole function: those pulses need the appropriate sequence and gate characteristics. The input and synchronization connections establish the unit's relationship with the controller and supply. The individual model defines its channel arrangement and any auxiliary features. In the complete equipment, this makes the trigger the link between the requested output and the firing action of the three-phase power stage, with each connection serving a specific branch.
Performance Features
The trigger waveform has good symmetry, with a control accuracy of ≤5%, high linearity, and stable operation.
High trigger power, capable of directly triggering thyristors up to 200A.
Supports multiple control signals: potentiometer (10K), DC 0~5V, DC 0~10V, and DC 4~20mA.
Features a soft-start function (3S); the power-on soft-start protects the thyristor and load from impact.
Features an output voltage limit function; the thyristor output voltage can be set arbitrarily.
Innovative and unique design; three-phase with no phase sequence restrictions; simple wiring and easy maintenance.
The main circuit and control circuit are fully isolated, ensuring safety and reliability.
Coated with a three-proof varnish that forms a transparent protective layer, providing superior protection against moisture, dust, and corrosion.
The trigger is equipped with a fault-lockout trigger pulse function; for example, if a pulse is blocked when the device is powered on, the
thyristors in the main circuit remain completely turned off.
Trouble Removal
If the power indicator light is off, power may not be supplied; if the operation indicator light is off, a control signal may not be connected.
When a control signal (0~5V, 0~10V, 4~20mA) is applied and the operation indicator light is on, but the thyristor does not output voltage, verify that a load is connected. Without a load, the thyristor has no current path and will not output voltage. You can first use a 10K potentiometer for manual control and debugging. test with a 100W~200W light bulb as the load, and confirm that all wires are connected correctly. Use a multimeter to measure the voltage between any two of the K2 terminals on the A, B, C, and trigger pulse ports. K2 is the synchronous signal sampling terminal; the voltage should match the voltage at the thyristor's input terminals. If they do not match, it indicates the connections are reversed; simply swap the K1-G1 and K2-G2 connections for Phases A, B, and C.
Typical Application
Where this module is used




Customized
Factory-direct flexibility
Product Highlights
FAQ
Common questions
Q: Does every model necessarily provide six outputs?
A: No. Confirm the channel count and purpose from the specific configuration.
Q: Should phase sequence be checked during replacement?
A: Yes. Follow the synchronization and connection requirements, including the mapping of trigger channels to the power branches.
Hot Tags: three phase thyristor trigger module, China three phase thyristor trigger module manufacturers, suppliers, factory, Single Phase Controlled Rectifier, Single Phase Power Regulator, Single Phase Rectifier Controller, Single Phase Thyristor Trigger Module, Three Phase Controlled Rectifier, Three Phase SCR Rectifier
Request a Quote
3 fields only
